Difference between Solaris 10 and Solaris11

-
Friends here it is a link, here you can find the all the information and features and benefits of Solaris 11. Please click on below link.
Difference Between Solaris 10 and Solaris 11

Please comments Please

Comments

Post a Comment

Popular posts from this blog

Veritas Cluster Server (VCS) Commands - Cheat Sheet

-
 LLT and GRAB VCS uses two components, LLT and GAB to share data over the private networks among systems. These components provide the performance and reliability required by VCS. LLT LLT (Low Latency Transport) provides fast, kernel-to-kernel comms and monitors network connections. The system admin configures the LLT by creating a configuration file (llttab) that describes the systems in the cluster and private network links among them. The LLT runs in layer 2 of the network stack GAB GAB (Group membership and Atomic Broadcast) provides the global message order required to maintain a synchronised state among the systems, and monitors disk comms such as that required by the VCS heartbeat utility. The system admin configures GAB driver by creating a configuration file ( gabtab). LLT and GAB files /etc/llthosts --> The file is a database, containing one entry per system, that links the LLT system ID with the hosts name. The file is identical on each server in the cluster. /etc...
Read more

Solaris 11.4 Network Administration Cheatsheet

-
 Here we discuss the Commonly used Network Commands for Solaris network Administration. How to list the Physical Network card's information : # dladm show-phys LINK            MEDIA         STATE      SPEED  DUPLEX    DEVICE net0            Ethernet      down       0      unknown   i40e0 net1            Ethernet      down       0      unknown   i40e1 net2            Ethernet      down       0      unknown   i40e2 net3            Ethernet      down       0      unknown   i40e3 net4            Ethernet    ...
Read more

Oracle Logical Domains (LDOM) Back up & Restoration from Backup Files

-
Saving Domain Configurations for Future Rebuilding The basic process is to save the resource constraints information for each domain into an XML file, which can then be re-issued to the Logical Domains Manager, for example, after a hardware failure to rebuild a desired configuration. Restore a Domain Configuration From an XML File ( ldm add-domain )  works for guest domains, but not for the control ( primary ) domain. You can save the  primary  domain's constraints to an XML file, but you cannot feed the file back into the  ldm add-domain -i  command. However, you can use the  ldm init-system  command and the resource constraints from the XML file to reconfigure your  primary  domain. You can also use the  ldm init-system  command to reconfigure other domains that are described in the XML file, but those domains are left inactive when the configuration is complete. The method that follows does not preserve actual bindings, only the ...
Read more